TIDIS ALP Locking Titanium Distal Tibia Plate
TIDIS II
Characteristics:
-Quality Raw Material Titanium Alloy (Ti6Al4V ELI, ASTM F136).
-Low Distal Profile 1.6mm.
-Rounded profile plate to reduce the risk of soft tissue irritation.
-Seven polyaxial holes (±15°) and two monoaxials to avoid joint damage to the fibula.
-Distal hole towards the tibial malleolus with 30° degree inclination + 15° degree polyaxial.
-Superficial Low Contact: Notches at the top of the plate allow blow vessel circulation.
TIDIS II ALP Locking Titanium Distal Tibia Plate
| Left (Code 165) / Right (Code 164) |
| 5, 7, 9, 11 and 13 Shaft Holes |
TIDIS
Characteristics:
-Quality Raw Material Titanium Alloy (Ti6Al4V ELI, ASTM F136).
– The locking holes in the distal area are parallel to the joint.
– The elongated hole in the shaft favors the initial positioning of the plate
-The shaft holes are compatible with 3.5mm locking screws on the threaded part and 3.5mm cortex screws on the compression part.
– The plate is twisted 20 degrees and bent to fit the distal tibia as it is anatomically molded.
TIDIS ALP Locking Titanium Distal Tibia Plate
| Left (Code 111) / Right (Code 110) |
| 5, 7, 9, 11 and 13 Shaft Holes |
| SCREWS |
|
3.5mm Titanium Cortex Locking Screw (Code 106, Length 12mm-60mm) 3.5mm Titanium Cancellous Locking Screw (Code 107, Length 12mm-60mm) 3.5mm Titanium Cortex Screw (Code 112, Length 12mm-60mm) |